Click here to visit the Home Page of Antenna Experts
Click here to visit the Home Page of Antenna Experts
 
 Model AP-2330-26 2305-2360 MHz 26 dBi Gain 
 

GRID PARABOLIC ANTENNA

Design Features:The AP-2330-26 grid parabolic antenna consists of full Parabolic reflector having a diameter of 1.8 Meters for use in point-to-point terrestrial analogue and digital communication systems. The mounting arrangement of grid parabolic Antenna permits to change the polarization from horizontal to vertical and vice-versa by mounting hardware fitted at rear end of the antenna. The antenna dipole feed uses an Air-Cored transmission line. The grid parabolic antenna operates at D.C. ground with low resistance discharge path for protection against lightning and immunity to noise.
Constructions: The AP-2330-26 grid parabolic antenna uses 6063T6 ultra corrosion resistant architectural anodized aluminum alloy. The parabolic reflector is illuminated by a primary feed horn which is fitted to the center of assembly with quick fastener system. Radiating elements and the dipole feed are made of high quality brass. All the screws, nuts and bolts of tactical microwave antenna are of stainless steel. The antenna supplied with army green color. The complete antenna is supplied with anti-corrosive powder coating finish and the dipole feed is completely sealed inside ABS housing/radome. The AP-2330-26 grid parabolic antenna supplied with elevation tracking mechanism where fine adjustments is necessary to optimize the signal strength of radio link
FCC Compliance: This grid parabolic antenna is 100% in compliance with FCC part 101.115 covering directional antenna especially the front to back ratio, beam-width and cross polarization discrimination..

Electrical Specifications:
Frequency Range2305-2360 MHz
Gain26 dBi
Bandwidth55 MHz
PolarizationVertical or Horizontal
Input Impedance50 Ohms
Radiation PatternDirectional
Beamwidth -3dB.7.4 Degrees (E&H)
Front to Back Ratio33 dB.
Cross Polarization32 dB.
VSWR - Equal To or Better Then< 1.3:1
RF Power Handling Capacity150 Watts
Input TerminationN-Female
Lightning ProtectionDirect Ground

Mechanical Specifications:
Antenna Materials6063T6 Aluminum Alloy
Mounting Hardware -MaterialsMarine Grade Stainless Steel
Wind Rating200 Km/Hr.
Support Pipe O.D.25.4 mm (1 Inch)
Support Pipe Material6063T6 Aluminum Alloy
Diameter of Parabolic Reflector1.2 Meters
Radiating MaterialHigh Quality Brass
Grid Members Material12.7 mm (1/2 Inch)
Maximum Mount Pipe Diameter 64 mm (2.5 Inches)
Gross Weight18 Kgs.

Environmental Specifications:
Operating Temperature(-) 30 to +70 Degrees Celsius
Storage Temperature(-) 40 to +80 Degrees Celsius
Humidity0 to 95% RH